driving voltage การใช้

• With proper device structure design, the driving voltage can be largely reduced.
• This driving voltage usually comes from another oscillator  sometimes called a " pump ".
• Stiction is the inability of the beam to release after removal of the drive voltage.
• Presently, the driving voltage of blue phase LCs in IPS structures is still a little bit too high.
• One can always test for nonlinear behavior by checking for a dependence of the resonance parameters on the driving voltage.
• Its magnitude depends on the drive voltage applied to the device and the wavelength of the interrogating laser relative to the exciton peak.
• These devices are used because of their good performance, but require a gate drive voltage a few volts above the power rail.
• Zinc has a relatively low driving voltage, which means in higher-resistivity soils or water it may not be able to provide sufficient current.
• Due to the charge storage characteristics of a capacitor, the bootstrap voltage will rise above ( V + ) providing the needed gate drive voltage.
• How quickly the torque falls off at faster speeds depends on the winding inductance and the drive circuitry it is attached to, especially the driving voltage.
• The potential advantages of OLEDs include thin, low-cost displays with a low driving voltage, wide viewing angle, and high contrast and color gamut.
• Later this same principle enabled Baehr-Jones et al . to demonstrate a mach-zehnder modulator with an exceptionally low drive voltage of 0.25 V
• Top line shows an in-phase piezoresponse to the driving voltage and the bottom line shows a 180?out-of-phase piezoresponse to driving voltage.
• Top line shows an in-phase piezoresponse to the driving voltage and the bottom line shows a 180?out-of-phase piezoresponse to driving voltage.
• The driving voltages required for light scattering are in the range of several ten volts and the non-trivial current is depending on the area of the activated segments.
• When the bias is negative the domain contracts giving a negative deflection as measured by the photodiode meaning that the piezoresponse will always be in-phase with the driving voltage.
• A series resistor in the " gate " lead would be wise, since current will flow in the gate-source circuit when the drive voltage is made positive.
• Some other types of light sources such as light-emitting diodes ( LEDs ), however, turn on and off extremely rapidly and would perceivably flicker if supplied with low frequency drive voltages.
• The force developed by the actuator is proportional to the change in capacitance between the two combs, increasing with driving voltage, the number of comb teeth, and the gap between the teeth.
• Since the EL-8 tubes are kept constantly lit, they don't have to be as bright, so the driving voltage can be lower and a separate high-voltage supply is not needed.